Adds a jogged segment
to a section object.
Access Methods
Ribbon: Mesh Modeling tab 
Section
panelSection
Plane JogNot available on the ribbon
in the current workspace. Shortcut menu: Right-click
a section line
Add
Jog to Section
Summary
You
can insert a jog, or angle, into a section object as you create
it. The jog is created on the section line. The jogged segment is
created at a 90-degree angle to the section line.
NoteThe SECTIONPLANEJOG
command was previously called JOGSECTION. Entering jogsection at
the Command prompt runs SECTIONPLANE JOG.
List of Prompts
The following prompts
are displayed.
- Select section object
-
Specifies which section
line to modify.
- Point on the section line to add jog
-
Specifies the location
of the jog.
